lock Warranty Information keyboard_arrow_down
Moog fulfills their warranty through their individual dealers. That means that in order to receive warranty support, you will have to refer back to the original dealer you purchased the part from. Be sure to check the dealer's warranty support before you buy the part to make sure that they will properly support the warranty. If a dealer will only refer you back to the manufacturer in order to receive warranty support, then you may not actually have any warranty at all.
WARRANTY:
Moog Premium Steering Components carry a Limited Lifetime Warranty. Moog R-Series Control Arms, Hub Assemblies, and Strut Assemblies carry a 3 Year Warranty.
Moog warranties their parts to be free of defects in materials and/or workmanship during these timeframes as measured from the date of purchase.
If a Moog part should fail due to materials or manufacturing defect while under warranty, we will provide a replacement of the part upon return of the defective part.
Wearable RUBBER parts are not covered under warranty (Dust boots, bushings, bump stops, etc.)

Product Reviews for Front Bump Stops - Chevrolet C10 - MOOG moog-k6607
- 5 Star (1)
-
-
- 100%
-
- 4 Star (0)
-
-
- 0%
-
- 3 Star (0)
-
-
- 0%
-
- 2 Star (0)
-
-
- 0%
-
- 1 Star (0)
-
-
- 0%
-
MOOG moog-k6607
starstarstarstarstar" very kewl "
Could not ask for better service, exact part for a great part. Thank you Emery
verified_user Verified Buyer - Emery Miller II - . MOOG moog-k6607 - 5 out of 5question_answer Customer Questions and Answers
- Question:
- Are these rubber or urethane?
- Answer:
- moog-k6607 is made of rubber.
- Question:
- I'm trying to install MOOG K6607 bumper on lower control arm. It was easy to pry off the old worn bumper, but the new one is resisting. Do you have any installation tips to get the new ones to pop in?
- Answer:
- Clean the slot the bump stop goes through with sand paper or emery cloth. Remove any burrs. Use some spray grease (silicone or WD40) on the barbed end and slot. Push the barbed end in the slot and grab the end with pliers or needle nose pliers and pu ull it through. ...see more