lock Warranty Information keyboard_arrow_down
Moog fulfills their warranty through their individual dealers. That means that in order to receive warranty support, you will have to refer back to the original dealer you purchased the part from. Be sure to check the dealer's warranty support before you buy the part to make sure that they will properly support the warranty. If a dealer will only refer you back to the manufacturer in order to receive warranty support, then you may not actually have any warranty at all.
Moog Premium Steering Components carry a Limited Lifetime Warranty. Moog R-Series Control Arms, Hub Assemblies, and Strut Assemblies carry a 3 Year Warranty.
Moog warranties their parts to be free of defects in materials and/or workmanship during these timeframes as measured from the date of purchase.
If a Moog part should fail due to materials or manufacturing defect while under warranty, we will provide a replacement of the part upon return of the defective part.
Wearable RUBBER parts are not covered under warranty (Dust boots, bushings, bump stops, etc.)
shuffle Cross References 1keyboard_arrow_down
Moog Tie Rods
Connecting the Driver to the Vehicle
Tie rods are a crucial part of your steering system. When you turn your steering wheel the motion travels through the steering rack, through the tie rods, and finally through your steering arm or spindle. Without tie rods, you wouldn't be able to turn your car. This part is also incredibly important to your vehicle's alignment. If you replace your tie rods, make sure to get an alignment done immediately afterward.
Designed for Strength, Durability, and Longevity
Moog tie rods feature several differences from the OE. One of the more obvious differences is the overall design itself. Whereas many OE tie rods are two-piece assemblies, Moog's tie rods are forged one-piece units. This one-piece design reduces the chance of early wear, increasing the durability of the part as a whole. To protect your tie rod, Moog uses a neoprene-sealed rubber dust boot. This dust boot is resistant to both extreme temperatures and abrasion. The design for this rubber boot includes a small valve to allow for the flushing of old grease and contaminants. In addition to all these other features, Moog crafts their tie rod end using hardened full-ball metal studs. These hardened studs can stand up to much more than the OE, making the tie rod that much more dependable.
Product Reviews for moog-ev433 | Front Inner Tie Rod | Toyota 4Runner | Moog-EV433
- 5 Star (5)
- 4 Star (0)
- 3 Star (0)
- 2 Star (0)
- 1 Star (0)
starstarstarstarstar" Excellent "
Easy installation, If you know what youre doing. Grease fitting a major plus.verified_user Verified Buyer - Christopher B. Chandler - . MOOG moog-ev433 - 5 out of 5
starstarstarstarstar" Better built than my original parts "
Only one of my inner tie rod ends had gone but you know how it is; once the job starts you just keep going and going and going. Anyway, with four flat sides instead of just two it makes installation and removal way easier than the two sided versions in my 2002 Tacoma 4x4. Handy that it comes pre-greased and also comes with the nut and thrust washer. The part seems beefier than my original tie rod end so no worries in harsh terrain.verified_user Verified Buyer - Darin Langhorst - . MOOG moog-ev433 - 5 out of 5
starstarstarstarstar" aok "
seamlessverified_user Verified Buyer - John Freeman - . MOOG moog-ev433 - 5 out of 5
starstarstarstarstar" Great "
The inner tie rods are easy to install but the old tie rods may be a little pain to take off.verified_user Verified Buyer - Pavel Galeta - . MOOG moog-ev433 - 5 out of 5