lock Warranty Information keyboard_arrow_down
Moog fulfills their warranty through their individual dealers. That means that in order to receive warranty support, you will have to refer back to the original dealer you purchased the part from. Be sure to check the dealer's warranty support before you buy the part to make sure that they will properly support the warranty. If a dealer will only refer you back to the manufacturer in order to receive warranty support, then you may not actually have any warranty at all.
WARRANTY:
Moog Premium Steering Components carry a Limited Lifetime Warranty. Moog R-Series Control Arms, Hub Assemblies, and Strut Assemblies carry a 3 Year Warranty.
Moog warranties their parts to be free of defects in materials and/or workmanship during these timeframes as measured from the date of purchase.
If a Moog part should fail due to materials or manufacturing defect while under warranty, we will provide a replacement of the part upon return of the defective part.
Wearable RUBBER parts are not covered under warranty (Dust boots, bushings, bump stops, etc.)
Front Lower Control Arm Bushing | 1995-2005 Cavalier
The MOOG k6698 Front Lower Control Arm Bushing can replace worn out bushings and help stabilize the vehicle when it drives. Original bushings may start to fail when they are exposed to too much heat, age, exposure, and general stress. When they do fail, the vehicle may experience popping and clanking noises and wheel shimmy. When installed, these bushings will help make the vehicle feel like it's fresh out of the dealership again. These bushings keep the control arm of vehicles like the 95-05 Chevrolet Cavalier secure and are an excellent replacement for bushings that have broken down.
What Happens when this Bushing Fails?
The OE control arm bushings were made with gaps in the upper and lower halves and their purpose is to decrease the vibrations in the vehicle. However, these gaps make the bushing more prone to failing and/or breaking. If the bushing fails and the control arm comes loose, it would cause the front end of the vehicle to "wobble." Also, the vehicle may experience steering wander and wheel shimmy from the misalignment caused by worn bushings. When the wheels misalign, the tires of the vehicles will wear unevenly as the wheels are leaning to one particular side during a turn.
The Benefit of this Part's Design.
Because these bushings are made of one solid piece they are not as good at absorbing vibrations as ones with indents. However, because of their sturdy structure, they are more resilient and malleable. To ensure quality, MOOG tests every part to make sure that every part is ready for any customer. Because of their simple round design, they also provide a smoother ride for the driver. This bushing is one of the best ways to reduce the strain on the suspension and keep the ride smooth.
So if you would like to keep you vehicle wobble-free and smooth pick up a set of these k6698 Front Lower Control Arm Bushings as soon as you can!
question_answer Customer Questions and Answers
- Question:
- What are the inner and outer dimensions of this bushing?
- Answer:
- Here are the dimensions listed in the Moog online catalog for moog-k6698: Inside Diameter (IN) 0.570 Outside Diameter (IN) 2.360
- Question:
- What is the bushing made of?
- Answer:
- Part number moog-k6698 is made of Steel Clad Rubber.