moog-ev800328 | Moog Inner Tie Toyota Rav4 | EV800328

  • moog-ev800328 Front Inner Tie Rod End
  • moog-ev800328 Front Inner Tie Rod End

Front Inner Tie Rod End

Manufacturer: MOOG
Part Number: moog-ev800328
Price: $33.48

check_box In Stock check_box Ships Immediately


  • Moog fulfills their warranty through their individual dealers. That means that in order to receive warranty support, you will have to refer back to the original dealer you purchased the part from. Be sure to check the dealer's warranty support before you buy the part to make sure that they will properly support the warranty. If a dealer will only refer you back to the manufacturer in order to receive warranty support, then you may not actually have any warranty at all.

    WARRANTY:

    Moog Premium Steering Components carry a Limited Lifetime Warranty. Moog R-Series Control Arms, Hub Assemblies, and Strut Assemblies carry a 3 Year Warranty.

    Moog warranties their parts to be free of defects in materials and/or workmanship during these timeframes as measured from the date of purchase.

    If a Moog part should fail due to materials or manufacturing defect while under warranty, we will provide a replacement of the part upon return of the defective part.

    Wearable RUBBER parts are not covered under warranty (Dust boots, bushings, bump stops, etc.)

Cross Reference from moog-ev800328 to beckarnley-101-5838
Beck Arnley beckarnley-101-5838
. Standard OE replacement.
Price: $35.00
Warranty: 3 Years or 50000 Miles

question_answer Ask us a Question

FitmentFront Inner Tie Rod End moog-ev800328 fits these vehicles:

moog-ev800328 | Moog Inner Tie Toyota Rav4 | EV800328

Moog Tie Rods

Connecting the Driver to the Vehicle

Tie rods are a crucial part of your steering system. When you turn your steering wheel the motion travels through the steering rack, through the tie rods, and finally through your steering arm or spindle. Without tie rods, you wouldn't be able to turn your car. This part is also incredibly important to your vehicle's alignment. If you replace your tie rods, make sure to get an alignment done immediately afterward.

Moog Tie Rod Box
Moog Tie Rod

Designed for Strength, Durability, and Longevity

Moog tie rods feature several differences from the OE. One of the more obvious differences is the overall design itself. Whereas many OE tie rods are two-piece assemblies, Moog's tie rods are forged one-piece units. This one-piece design reduces the chance of early wear, increasing the durability of the part as a whole. To protect your tie rod, Moog uses a neoprene-sealed rubber dust boot. This dust boot is resistant to both extreme temperatures and abrasion. The design for this rubber boot includes a small valve to allow for the flushing of old grease and contaminants. In addition to all these other features, Moog crafts their tie rod end using hardened full-ball metal studs. These hardened studs can stand up to much more than the OE, making the tie rod that much more dependable.

question_answer Customer Questions and Answers


Question:
Does tie rod come with grease for applying to the ball joint proper?
Answer:
No. Moog-ev800328 is greased after it is assembled and needs no further maintenance.

Question:
Does part number ev800328 come in a pair or is it sold individually?
Answer:
Part number ev800328 is sold individually.

Question:
Where is part number EV800328 manufactured?
Answer:
Moog parts are actually manufactured all over the world, so there is not one set location as to where the EV800328 was manufactured. Check out our blog that explains the whole process at https://www.suspension.com/blog/where-are-moog-parts-made/

Question:
Will part number ev800328 fit my 2009 Toyota rav4 4wd? Also, what are the specs of this?
Answer:
Yes, part number ev800328 will fit the 2009 Toyota rav4 4wd. It has a length of 9.650 inches, the outer tie rod thread is M16x1.5-6G RH, the shaft diameter is .704 inches and the rack end thread is M6x1.5-6G RH.